Module - 2nd Row Seat Controller - LH (5 Seat) (Remove and Replace)
Correction code 13023012 0.15 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
- 2023-06-22: Seat controller module assignment routine added, firmware reinstall step modified.
Remove
- Open the LH front door and lower the LH front window.
- Move the driver seat forward.
- Open the LH falcon wing door.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Disconnect LV power. See LV Power (Disconnect and Connect).
-
Release the LH 2nd row seat cushion
tensioning J-hooks (x2) from the back trim retention wire.
NoteOnly release the J-hooks behind seat ECU connections.
-
Disconnect the electrical connectors
(x2) from the LH 2nd row seat controller module.
-
Remove the screws (x3) that attach the
LH 2nd row seat controller module to the seat assembly, and then remove the module from
the seat assembly.
Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
Install
-
Position the LH 2nd row seat
controller module into the seat assembly, and then install the screws (x3) that attach
the module to the seat assembly.Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
-
Connect the electrical connectors (x2) to the LH 2nd row seat controller
module.
-
Attach the LH 2nd row seat cushion
tensioning J-hooks (x2) to the back trim retention wire.
- Connect LV power. See LV Power (Disconnect and Connect).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
-
Calibrate the rear doors.
NoteIf the message "Calibration Required" appears on the vehicle touchscreen, touch and hold Calibrate to calibrate the rear doors.
- Move the driver seat to the original position.
- Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
-
In Toolbox, select the Actions tab, and then search for
"BCS2L".
NoteWhen servicing the RH side module, search for "BCS2R".
-
Click BCS2L_Side_Assignment_Procedure, click
Run, and allow the routine to complete.
NoteWhen servicing the RH side module, run the BCS2R_Side_Assignment_Procedure.
- Reinstall the firmware. See Firmware Reinstall - Touchscreen.
- Disconnect the laptop from the vehicle. See Toolbox 3 (Connect and Disconnect).
- Raise the LH front window and close the LH front door.