2025-06-27

Sensor - Pressure - Door - Front - LH (Remove and Replace)

Correction code 20200102 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2025-06-27: Added the LV battery disconnect/connect steps.

Remove

  1. Disconnect the LV battery power. See LV Power (Disconnect and Connect).
  2. Remove the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace).
  3. Release the connector lock, and then disconnect the LH front door pressure sensor electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not push down on the red tab. Pull the red tab to disengage lock, and then pull again to release the connector.
  4. Rotate the inner section of the LH front door pressure sensor counter-clockwise to release it from the door assembly, and then remove the sensor from the door assembly.

Install

  1. Position the LH front door pressure sensor into the LH front door assembly, and then rotate the inner section of the sensor clockwise to secure it to the door.
  2. Connect the LH front door pressure sensor electrical connector, and then engage the locking tab.
  3. Install the LH front door trim panel. See Panel - Door Trim - Front - LH (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    Connect the LV battery power as needed. See LV Power (Disconnect and Connect).
  4. Hold the LH and RH upper B-pillar buttons in the down position to manually calibrate the LH and RH falcon wing doors.