17/06/2022 13:08:47

Wheel Arch Liner - Front - LH (Remove and Replace)

Correction code 12010902 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Move the vehicle to a 2 post lift. See Raise Vehicle - 2 Post Lift.
  2. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  3. Release the clip and the tabs (x8) that attach the LH front wheel arch liner cover to the LH front wheel arch liner, and then remove the cover from the liner.
  4. Remove the clip that attaches the LH front wheel fairing to the LH front wheel arch liner.
  5. Remove the bolts (x2) and release the tab that attach the LH front wheel fairing to the valance, and then remove the fairing from the valance.
  6. Starting from the rear and working forward, release the clips (x5) and tabs (x9) that attach the LH front fender garnish to the body, and then disconnect the electrical harness from the parking sensor connector.
  7. Remove the push nuts (x2) that attach the LH front wheel arch liner to the body.
  8. Release the clips (x3) that attach the front portion of the LH front wheel arch liner to the body.
  9. Release the clips (x2) that attach upper portion of the LH front wheel arch liner to the body.
  10. Release the clips (x6) that attach the rear portion of the LH front wheel arch liner to the body, and then remove the wheel arch liner from the vehicle.

Install

  1. Install the LH front wheel arch liner into the LH front wheel arch, and then install the push nuts (x2) that attach the wheel arch liner to the body.
  2. Fasten the clips (x2) that attach upper portion of the LH front wheel arch liner to the body.
  3. Fasten the clips (x6) that attach the rear portion of the LH front wheel arch liner to the body.
  4. Fasten the clips (x3) that attach the front portion of the LH front wheel arch liner to the body.
  5. Connect the electrical harness to the LH front fender garnish parking sensor connector, and then starting from the front and working rearward, fasten the clips (x5) and tabs (x9) that attach the fender garnish to the body.
  6. Install the LH front wheel fairing to the valance, and then fasten the tab and install the bolts (x2) that attach the wheel fairing to the valance.
    1.5 Nm (1.1 lbs-ft)
  7. Fasten the clip that attaches the LH front wheel fairing to the LH front wheel arch liner.
  8. Install the LH front wheel arch liner cover to the LH front wheel arch liner, and then fasten the clip and the tabs (x8) that attach the cover to the liner.
  9. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  10. Remove the vehicle from the 2-post lift. See Raise Vehicle - 2 Post Lift.