Heater - Radar (Rework) (Vehicles Built After July 1, 2021)
Correction code 17201806 0.78 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
- 2024-12-18: Updated title and procedure details.
Rework
- Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install).
-
Disconnect the radar heater electrical
connector.
- Cut the radar heater harness near the radar heater.
-
Install a dummy plug (1471057-00-A)
onto the fascia harness that goes to the radar heater.
- Insert plugs (1015293-00-A) onto the back of the connector dummy plug.
- Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install).