Sensor - Impact - B-Pillar - LH (Remove and Replace)
Correction code
20200502
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate Times to learn
more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make sure proper PPE is worn when
performing the below
procedure.
Remove
- Open the LH doors and lower the front windows.
- Move the driver seat rearward.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Disconnect LV power. See LV Power (Disconnect and Connect).
- Remove the LH lower B-pillar trim. See Trim - B-Pillar - Lower - LH (Remove and Replace).
-
Release the connector lock, and then
disconnect the LH B-pillar impact sensor electrical connector.
CAUTIONDo not push down on the red tab. Pull the red tab to disengage the lock and then pull again to release the connector.
-
Remove and discard the bolt that
attaches the LH B-pillar impact sensor to the vehicle, and then remove the sensor from
the vehicle.8 Nm (5.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- T30 socket
Install
-
Position the LH B-pillar impact sensor into the vehicle, and then install a new bolt
that attaches the sensor to the vehicle.8 Nm (5.9 lbs-ft)TIpUse of the following tool(s) is recommended:
- T30 socket
- Connect the LH B-pillar impact sensor electrical connector, and then secure the locking tab.
- Install the LH lower B-pillar trim. See Trim - B-Pillar - Lower - LH (Remove and Replace).
- Connect LV power. See LV Power (Disconnect and Connect).
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Move the driver seat to the original position.
-
Calibrate the rear doors.
NoteIf the "Calibration Needed" message appears on the vehicle touchscreen, touch and hold Calibrate to calibrate the rear doors.
- Raise the front windows and close the LH front door.