13/04/2023 01:02:51

Sensor - Radar - Front (Remove and Replace)

Correction code 17201602 1.44 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-04-13: Cleaned up.

Remove

  1. Remove the front fascia assembly. See Fascia Assembly - Front (Remove and Install)。
  2. Disconnect the electrical connector from the front radar sensor.
  3. Remove the tabs (x2) that attach the front radar sensor to the front end carrier.

Install

  1. Position the front radar sensor into the vehicle and install the tabs (x2) that attach the front radar sensor to the front end carrier.
  2. Connect the electrical connector from the front radar sensor.
  3. Install the front fascia assembly. See Fascia Assembly - Front (Remove and Install)
  4. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  5. Unlock the vehicle gateway. See Gateway (Unlock).
  6. In Toolbox 3, click the Actions tab, type "Service-Redeploy" into the search field, click SERVICE CAN REDEPLOY, click Run, and allow the routine to complete.
  7. Adjust the ride height. See Ride Height (Adjust).
  8. Calibrate the front radar sensor. Sensor - Radar - Front (Calibration).
  9. Disconnect Toolbox and remove the laptop from the vehicle. See Toolbox 3 (Connect and Disconnect).