04/08/2022 09:48:50

Floor Supports - Rear - 2nd Row - RH (Remove and Replace)

Correction code 153036420.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH and RH front doors.
  2. Lower the LH and RH front windows.
  3. Open the LH and RH falcon wing doors.
  4. Move the LH front seat forward.
  5. Fold the 2nd row 60 seat downwards.
  6. Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  7. Move the RH front seat forward.
  8. Fold the 2nd row 40 seat downwards.
  9. Remove the RH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  10. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  11. Remove the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  12. Remove the trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  13. Remove the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (5 Seat) (Remove and Replace).
  14. Remove the 2nd row rear floor panel. See Floor Panel - Rear - 2nd Row (5 Seat) (Remove and Replace).
  15. Use a plastic wedge to release the adhesive that attaches the RH 2nd row rear floor supports to the vehicle, and then remove the supports from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Plastic trim tool

Install

  1. Use IPA wipes to clean the RH 2nd row rear floor supports mounting surface area.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 minute of dry time.
  2. Remove the adhesive backing from the RH 2nd row rear floor supports, position the supports on the vehicle, and then press down firmly to install the supports to the vehicle.
  3. Install the 2nd row rear floor panel. See Floor Panel - Rear - 2nd Row (5 Seat) (Remove and Replace).
  4. Install the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (5 Seat) (Remove and Replace).
  5. Install the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  6. Move the LH front seat to original position.
  7. Install the RH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  8. Move the RH front seat to original position.
  9. Install the trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  10. Install the front trunk load floor. See Trunk Load Floor - Front (Remove and Replace).
  11. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  12. Close the liftgate.
  13. Close the LH and RH falcon wing doors.
  14. Raise the LH and RH front windows.
  15. Close the LH and RH front doors.