01/02/2023 14:41:04

Cover - Harness - Rear View Mirror (Remove and Replace)

Correction code 15050002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the lower camera cover. See Camera Cover - Lower (Remove and Replace).
  2. Remove the rear view mirror. See Mirror - Rear View (Remove and Replace).
  3. Carefully pull down on the upper camera cover to release it from the clips (x4), and then lower the rear view mirror harness cover.
  4. Release the retaining tabs (x16) that attach the rear view mirror harness cover to the windshield bracket, and then slide the cover forward from the headliner to remove it from the vehicle.

Install

  1. Position the rear view mirror harness cover into the vehicle, slide the cover rearward into the headliner, and then secure the retaining clips (x16) that attach the cover to the windshield bracket.
  2. Position the upper camera cover onto the camera assembly, and then secure the clips (x4) that attach the cover to the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the rear view mirror harness is routed so that it hangs freely on the outside and is not pinched between the cover and glare shield assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Attach the camera upper cover to the rear view mirror harness cover before connecting the interior camera.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the cover as an assembly.
  3. Install the rear view mirror. See Mirror - Rear View (Remove and Replace).
  4. Install the lower camera cover. See Camera Cover - Lower (Remove and Replace).