2026-08-09

Decor Trim - Rear Door - LH (2025+) (Remove and Replace)

Correction code New FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Note
This procedure describes work that is specific to 2025+ Model X.
  • 2026-07-24: Updated post-repair ODIN routine to "TEST-SELF_VCLEFT_X_RGB-LIGHTS".

Remove

  1. Open the LH front door and lower the LH front window.
  2. Open the LH falcon wing door.
  3. Remove the clips (x7) that secure the LH rear decor trim panel, disconnect the harness connector, and then slide the trim rearward and push down the metal tabs (x2) to release the trim.

Install

  1. Connect the LH rear décor trim panel harness connector, secure the metal tabs (x2), and then slide the trim forward to install the clips (x7).
  2. Close the LH falcon door.
  3. Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox (Connect and Disconnect).
  4. On the laptop, click the Actions tab, type "TEST-SELF_VCLEFT_X_RGB-LIGHTS" into the search field, click TEST-SELF_VCLEFT_X_RGB-LIGHTSvia Toolbox:(link), click Run, and allow the routine to complete.
  5. Reinstall the vehicle firmware. See Firmware Reinstall - Touchscreen.
  6. Exit Service Mode. See Service Mode (Enable and Disable).
  7. Raise the LH front window and close the LH front door.