2026-09-25

Sensor - Crash Accelerometer - Front Bumper (Remove and Replace)

Correction code 20203102 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Note
Refer to the Parts Catalog to determine the appropriate replacement part for the vehicle.
CAUTION
Supplemental Restraint System (SRS) components can be hazardous if not serviced and handled correctly. See Air Bag and Supplementary Restraint System (SRS) Precautions
CAUTION
In the event of an airbag or seatbelt pretensioner deployment, certain components must be replaced, and other components must be inspected for damage. Refer to the Collision Repair Manual for a specific list of items that must be inspected and replaced.

Remove

  1. Remove the front fascia. See Fascia Assembly - Front (HW3) (Remove and Replace).
  2. Release the locking tab, and then disconnect the LH front bumper crash accelerometer sensor connector.
  3. Remove the bolt that attaches the LH front bumper crash accelerometer sensor to the vehicle, and then remove the sensor from the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the LH front bumper crash accelerometer sensor into the vehicle, and then install the bolt that attaches the sensor to the vehicle.
    10 Nm (7.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect the LH front bumper crash accelerometer sensor connector, and then engage the connector lock.
  3. Install the front fascia. See Fascia Assembly - Front (HW3) (Remove and Replace).