10/11/2022 08:09:48

Side Shield - Inboard - 2nd Row Seat - RH (5 Seat) (Remove and Replace)

Correction code 13085202 1.08 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the RH 2nd row seat assembly from the vehicle. See Seat Assembly - 2nd Row - RH (5 Seat) (Remove and Replace).
  2. Release the clip that attaches the RH 2nd row seat belt buckle harness to the side shield.
  3. Release the clip and tabs (x4) that attach the RH 2nd row seat inboard side shield to the seat assembly, and then remove the side shield from the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the side shield away from the seat assembly to release the clip, and then release the tabs from the bottom up. Lift the side shield to release the top edge from the seat frame.

Install

  1. Position the RH 2nd row seat inboard side shield onto the RH 2nd row seat assembly, and then secure the clip and tabs (x4) that attach the side shield to the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the upper tabs down onto the seat frame, and then secure clip and remaining tabs.
  2. Secure the clip that attaches the RH 2nd row seat belt buckle harness to the side shield.
  3. Install the RH 2nd row seat assembly into the vehicle. See Seat Assembly - 2nd Row - RH (5 Seat) (Remove and Replace).