17/06/2022 13:14:56

Carrier - LH - Side Shield - Outboard - Front Seat (Remove and Replace)

Correction code 13070012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the driver seat outboard side shield assembly from the driver seat. See Side Shield - Outboard - Driver Seat (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the back rest and cushion adjust switch from the trim assembly after removing the trim from the seat.
  2. Release the clips (x2) and tabs (x2) that attach the front seat side shield LH carrier to the seat assembly, and then remove the carrier from the vehicle.
    Tip: Release the front clips first, and then clear the rear tabs and rotate the trim away from the seat frame.

Install

  1. Position the front seat side shield LH carrier onto the seat assembly, and then secure the clips (x2) and tabs (x2) that attach the carrier to the seat assembly.
    Tip: Rotate the trim to secure the rear tabs into frame, and then secure the front clips.
  2. Install the driver seat outboard side shield assembly. See Side Shield - Outboard - Driver Seat (Remove and Replace).