Cladding - Door - Rear - LH (Remove & Replace)
Correction code 12204202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
-
Open the LH falcon wing door.
NoteOpen the door to a comfortable working height.
-
Starting from the front of the
cladding, release the clips (x4) and double sided tape strip that attach the LH rear
door cladding to the door assembly.
CAUTIONTake care not to damage painted surfaces.
-
Release the lower clip that attaches
the LH wheel arch door rear cladding to the door.
-
Use IPA wipes to clean the back side
edge of the LH rear wheel arch door cladding.
NoteAllow 1 minute of dry time.
Install
-
Use IPA wipes to clean the LH rear
door cladding surface area.
NoteAllow 1 minute of dry time.
-
Remove the adhesive backing on the LH
rear door cladding, position the cladding onto the LH rear door, and then secure the
clips (x4) that attach the cladding to the door.
-
Secure the lower clip that attaches
the LH rear wheel arch door cladding to the door assembly.
NoteRemove the backing from the double side tape, and then apply even pressure along the cladding with a seam roller to ensure adhesion to the body.
- Close the LH falcon wing door.