19/10/2022 14:41:47

Duct - Rocker - 3rd Row - RH (Remove and Replace)

Correction code 18101602 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open all four doors.
  2. Lower the LH and RH front windows.
  3. Move the LH and RH front seats forward.
  4. Remove the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  5. Open the liftgate.
  6. Remove the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (6 Seat) (Remove and Replace).
  7. Move the LH and RH monopost seats forward.
  8. Remove the LH and RH side rear trunk garnishes. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  9. Remove the LH and RH mid C-pillar trims. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  10. Remove the LH and RH lower C-pillar trims. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  11. Remove the 2nd row rear floor panel. See Floor Panel - Rear - 2nd Row (6 Seat) (Remove and Replace).
  12. Remove the bolts (x2) that attach the RH 3rd row rocker duct to the body, and then remove the duct from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • 4 in extension
    • 10 mm socket
    • Ratchet/torque wrench

Install

  1. Position the RH 3rd row rocker duct on the vehicle, and then install the bolts (x2) that attach the duct to the body.
    2.5 Nm (1.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 4 in extension
    • 10 mm socket
    • Ratchet/torque wrench
  2. Install the 2nd row rear floor panel. See Floor Panel - Rear - 2nd Row (6 Seat) (Remove and Replace).
  3. Install the LH and RH lower C-pillar trims. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  4. Install the LH and RH mid C-pillar trims. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  5. Install the LH and RH side rear trunk garnishes. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  6. Move the LH and RH monopost seats into original position.
  7. Close the liftgate.
  8. Install the 2nd row mid floor panel. See Floor Panel - Mid - 2nd Row (6 Seat) (Remove and Replace).
  9. Install the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  10. Move the LH and RH front seats into original position.
  11. Calibrate the rear doors.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the "Calibration Needed" message appears on the vehicle touchscreen, touch and hold Calibrate to calibrate the rear doors.
  12. Raise the LH and RH front windows.
  13. Close the LH and RH front doors.