2023-11-08

Hose - Outlet - Radiator (Remove and Replace)

Correction code 18302702 1.02 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-10-31: Reorganized the procedure.

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  3. Disconnect LV power. See LV Power (Disconnect and Connect).
  4. Remove the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
  5. Remove the front skidplate. See Skidplate - Front (Remove and Replace).
  6. Place a coolant catcher under the LH front of the vehicle.
  7. Lower the vehicle fully.
  8. Place absorbent material under the supermanifold.
  9. Release the clip, disconnect the radiator outlet hose from the supermanifold, then immediately plug both fittings.
  10. Release the clip, disconnect the radiator outlet hose from the radiator, then immediately plug both fittings.

Install

  1. Remove the plugs, immediately connect the radiator outlet hose to the radiator, then fasten the clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test on the fittings to make sure that they are secure.
  2. Remove the plugs, immediately connect the radiator outlet hose to the supermanifold, then fasten the clip.
    Informational PurposesAn informational icon, calling your attention
    Note
    Perform a push-pull-push test on the fittings to make sure that they are secure.
  3. Remove the absorbent material from under the supermanifold and wipe off any residue.
  4. Raise the vehicle to a comfortable working height.
  5. Remove the coolant catcher from under the vehicle.
  6. Install the front skidplate. See Skidplate - Front (Remove and Replace).
  7. Install the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
  8. Connect LV power. See LV Power (Disconnect and Connect).
  9. Perform the cooling system (partial refill and bleed) procedure. See Cooling System (Partial Refill and Bleed).
  10. Install the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  11. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  12. Disable Service Mode. See Service Mode (Enable and Disable).
  13. Press and hold the lower button on each upper B-pillar to calibrate the falcon wing doors.
  14. Remove the vehicle from the 2 post lift. See Raise Vehicle - 2 Post Lift.