2022-07-27

Light - Fog/Reverse - Rear - LH (Remove and Replace)

Correction code 17402702 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the liftgate applique. See Applique - Liftgate (Remove and Replace).
  2. Remove the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  3. Disconnect the liftgate cinching actuator electrical connector.
  4. Remove the bolts (x3) that attach the liftgate cinching actuator assembly to the liftgate, and then remove the assembly from the liftgate.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm socket
  5. Remove the LH liftgate tail light side cover. See Cover - Side - Tail Light - Liftgate - LH (Remove and Replace).
  6. Remove the nuts (x3) that attach the LH rear fog/reverse light to the liftgate, disconnect the electrical connector. and then remove the light from the liftgate.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket

Install

  1. Position the LH rear fog/reverse light into the liftgate, connect the electrical connector. and then install the bolts (x3) that attach the light to the liftgate.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
  2. Install the LH liftgate tail light side cover. See Cover - Side - Tail Light - Liftgate - LH (Remove and Replace).
  3. Position the liftgate cinching actuator assembly into the liftgate, and then install the bolts (x3) that attach the actuator assembly to the liftgate.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm socket
  4. Connect the liftgate cinching actuator electrical connector.
  5. Install the lower liftgate trim. See Trim - Liftgate - Lower (Remove and Replace).
  6. Install the liftgate applique. See Applique - Liftgate (Remove and Replace).