10/11/2022 08:13:02

Bracket - Escutcheon - Seatbelt - 2nd Row - Center (5 Seat) (Remove and Replace)

Correction code 20056612 1.80 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH 2nd row seat seat back sub-assembly. See Seat Back Sub-Assembly - 2nd Row Seat - LH (5 Seat) (Remove and Replace).
  2. Remove the bolts (x2) that attach the center 2nd row seatbelt escutcheon bracket to the seat assembly, release the tabs (x2) that attach the escutcheon rear cover to the assembly, and then remove the bracket from the seat assembly.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Release the rear cover of the escutcheon before removal.
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the center 2nd row seatbelt escutcheon bracket onto the seat assembly, route the seatbelt over the center guide, secure the tabs (x2) that attach the escutcheon rear cover to the assembly, and then install the bolts (x2) that attach the bracket to the seat assembly.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Install the LH 2nd row seat seat back sub-assembly. See Seat Back Sub-Assembly - 2nd Row Seat - LH (5 Seat) (Remove and Replace).