22/06/2022 16:00:41

Cover - Bracket - 3rd Row - Center (Remove and Replace)

Correction code 13094302 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the liftgate.
  2. Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  3. Remove the trunk tub floor insulator.
  4. Remove the trunk carpet.
  5. Fold the LH and RH 3rd row seat backs to the down position.
  6. Release the clip that attaches the center 3rd row bracket cover to the seat assembly, and then remove the cover from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the cover outward to release it.

Install

  1. Position the center 3rd row bracket cover into the seat assembly, and then secure the clip that attaches the cover to the seat assembly.
  2. Raise the LH and RH 3rd row seat backs to the upright position.
  3. Install the trunk carpet.
  4. Install the trunk tub floor insulator.
  5. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace).
  6. Close the liftgate.