2024-08-04

Latch - Hood (Single Actuator) (Remove and Replace)

Correction code 11355702 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Latch - Hood (Single Actuator) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the double pull single actuator hood latch to the front end carrier assembly
10 Nm (7.4 lbs-ft)
  • Flex head ratchet/flex head torque wrench
  • 10 mm deep socket
  • 2 in extension
 Reuse

Remove

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install).
  2. Disconnect the double pull single actuator hood latch wiring harness electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pull the red tab to release the connector lock, then pull the red tab again to release the connector.
  3. Compress the tabs (x2) to release the hood latch actuator and cable from the hood latch assembly.
  4. Remove the bolts (x2) that attach the double pull single actuator hood latch to the front end carrier assembly, and then remove the latch from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • 10 mm deep socket
    • 2 in extension

Install

  1. Position the double pull single actuator hood latch onto the front end carrier assembly, and then install the bolts (x2) that attach the latch to the assembly.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Flex head ratchet/flex head torque wrench
    • 10 mm deep socket
    • 2 in extension
  2. Install the hood latch actuator and cable into the double pull single actuator hood latch assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the tabs are fully engaged onto the hood latch assembly.
  3. Connect the double pull single actuator hood latch wiring harness electrical connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the red locking tab into the connector to engage the connector lock.
  4. Install the underhood storage unit. See Underhood Storage Unit (Remove and Install).