15/08/2022 14:35:18

Light - Map - Rear (Remove and Replace)

Correction code 17350802 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH and RH front doors.
  2. Lower the LH and RH front windows.
  3. Open the LH and RH falcon wing doors.
  4. Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  5. Open the liftgate.
  6. Fold the LH 3rd row seat downwards.
  7. Remove the LH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  8. Remove the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  9. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  10. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  11. Remove the LH and RH side rear coat hook. See Coat Hook - Rear - LH (Remove and Replace).
  12. Partially release the clips (x8) that attach the LH headliner to the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Clip pry tool
    • Plastic trim tool
  13. Disconnect the rear map light connector, and then release the connector from the harness guide.
    Informational PurposesAn informational icon, calling your attention
    Note
    Take note of any NVH measurements.
    Tip: Use of the following tool(s) is recommended:
    • Pocket screwdriver
  14. Release the clips (x2) that attach the rear map light to the headliner, and then remove the light from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Plastic trim tool

Install

  1. Position the rear map light onto the vehicle, and then install the clips (x2) that attach the light to the headliner.
    Informational PurposesAn informational icon, calling your attention
    Note
    Route the harness up into the headliner.
  2. Position the rear map light connector on the harness guide, and then connect the light connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Secure any NVH measurements noted.
  3. Install the clips (x8) that attach the LH headliner to the vehicle.
  4. Install the LH and RH side rear coat hook. See Coat Hook - Rear - LH (Remove and Replace).
  5. Install the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  6. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  7. Install the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  8. Install the LH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  9. Unfold the LH 3rd row seat to original position.
  10. Close the liftgate.
  11. Install the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  12. Close the LH and RH falcon wing doors.
  13. Raise the LH and RH front windows.
  14. Close the LH and RH front doors.