Panel - Door Trim - Rear - LH (Remove and Replace)
Correction code 15132002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Remove the LH rear door trim lower garnish. See Garnish - Lower - Door Trim - Rear - LH (Remove and Replace).
- Remove the LH rear door trim decor. See Decor - Trim - Rear Door - LH (Remove and Replace).
-
Remove the bolts (x8) that attach the
LH rear door trim panel to the LH rear door.NoteUse of the following tool(s) is recommended:
- 10 mm socket
-
Release the clips (x13) that attach
the LH rear door trim panel to the LH rear door, disconnect the electrical connectors
(x2), and then remove the panel from the door.
Install
-
Position the LH rear door trim panel
onto the LH rear door, connect the electrical connectors (x2), and then secure the clips
(x13) that attach the panel to the door.
NoteInstall the trim panel starting from the top. Make sure the trim panel tap is fitted correctly on the inner belt seal.
-
Install the bolts (x8) that attach the LH rear door trim panel to the LH rear
door.NoteUse of the following tool(s) is recommended:
- 10 mm socket
- Install the LH rear door trim decor. See Decor - Trim - Rear Door - LH (Remove and Replace).
- Install the LH rear door trim lower garnish. See Garnish - Lower - Door Trim - Rear - LH (Remove and Replace).