2025-03-10

Panel - Door Trim - Front - LH (Remove and Replace)

Correction code 15130202 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  2. Remove the LH front door trim reflector. See Reflector - Door Trim - Front - LH (Remove and Replace).
  3. Remove the service covers (x2), and then remove the bolts (x2) that attach the LH front door trim panel to the LH front door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T30 socket
  4. Release the clips (x10) that attach the LH front door trim panel to the LH front door to access the release cable and connector, release the release cable, release the connector lock and disconnect the electrical connector, and then remove the panel from the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Carefully pry open the LH front door trim panel to access the connector and release cable.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace any broken clips.

Install

  1. Position the LH front door trim panel onto the LH front door, secure the release cable, connect the electrical connector and engage the connector lock, and then secure the clips (x10) that attach the panel to the door.
  2. Install the bolts (x2) that attach the LH front door trim panel to the LH front door, and then install the service covers (x2).
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T30 socket
  3. Install the LH front door trim reflector. See .
  4. Install the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  5. Close the LH front door.
  6. Check the gap fitment of the LH front door trim decor to the IP decor.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for current specifications.
  7. Remove the LH front door trim decor. See Reflector - Door Trim - Front - LH (Remove and Replace).
  8. Adjust the LH front door trim panel as needed.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Loosen the T30 fastener to make adjustments. Rotate the adjustment nut clockwise to close the gap or counter-clockwise to widen the gap. Torque the T30 fastener to lock the adjustment nut.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 18 mm socket
  9. Install the LH front door trim decor. See Decor - Trim - Front Door - LH (Remove and Replace).
  10. Redeploy the firmware. See Firmware Reinstall - Toolbox.