17/06/2022 13:06:03

Cover - Lower Latch - Door - Rear - LH (Remove and Replace)

Correction code 11350602 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH falcon wing door.
  2. Apply masking tape around the LH rear door lower latch cover to mark the position of the latch.
  3. Remove and discard the screws (x2) that attach the LH rear door lower latch cover to the vehicle, and then remove the cover from the vehicle.
    22 Nm (16.2 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • T30 socket

Install

  1. Position the LH rear door lower latch cover into the vehicle, and then install new screws (x2) that attach the cover to the vehicle.
    22 Nm (16.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the latch cover lines up with tape marks.
    Tip: Use of the following tool(s) is recommended:
    • T30 socket
  2. Remove the masking tape around the LH rear door lower latch cover.
  3. Close the LH falcon wing door.
  4. Check the gap and flush measurements and adjust as necessary.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to CVIS for current gap and flush specifications.