2026-04-27

Lamp - Reflex - Rear - LH (Remove and Replace)

Correction code 17403502 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2026-04-27: Updated steps to latest time study. Removal of rear fascia no longer required.

Remove

  1. Use IPA wipes to clean the lower rear fascia at the reflex reflector area.
  2. Use a wide trim tool to release the clips (x2) that attach the LH side reflex lamp to the lower rear fascia assembly, and then remove the lamp from the assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    The clips may break during removal. Discard the reflector after removal.
    Figure 1. Rear fascia removed for clarity
    Figure 2. Rear fascia removed for clarity

Install

  1. Position the LH side reflex lamp into the lower rear fascia assembly, and then secure the clips (x2) that attach the lamp to the assembly.
    Figure 3. Rear fascia removed for clarity
    Figure 4. Rear fascia removed for clarity