17/06/2022 13:07:30

Protector - Lower Edge - Rear Door - LH (Remove and Replace)

Correction code 11707302 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH falcon wing door.
  2. Remove the LH rear door lower edge protector.

Install

  1. Remove any remaining adhesive from the door, and then use IPA wipes to clean the mating surface.
    Informational PurposesAn informational icon, calling your attention
    Note
    Allow 1 min for the IPA to dry.
  2. Install the LH rear door lower edge protector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove adhesive film if required.
  3. Close the LH falcon door.