Wiper Arm - RH (Remove and Replace)
Correction code 17500352 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
-
Release the RH wiper arm hose
nozzle.
-
Remove the RH wiper arm nut covers
(x2).
-
Remove the nuts (x2) that attach the
RH wiper arm to the vehicle, and then use a wiper arm removal tool to remove the wiper
arm from the vehicle.CAUTIONDo not flex the wiper arm to remove it.NoteLower the hood slightly to fit the wiper arm removal tool.Tip: Use of the following tool(s) is recommended:
- 15 mm socket
- Wiper Arm Removal Tool - 1058696-00-A
Install
-
Position the RH wiper arm into the
vehicle, and then install the nuts (x2) that attach the wiper arm to the vehicle.NoteLine up the wiper to the reference mark on the windshield.Tip: Use of the following tool(s) is recommended:
- 15 mm socket
-
Install the RH wiper arm nut covers (x2).
-
Secure the RH wiper arm hose nozzle.
NoteMake sure the hose is routed below the arm pivot.
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Raise the LH front window and close the LH front door.