18/10/2022 15:19:18

Funnel - Drain - HVAC (Remove and Replace)

Correction code 18103612 5.04 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the HVAC assembly. See HVAC Assembly (Remove and Replace).
  2. Release the tabs (x2) that attach the HVAC drain funnel to the bulkhead, and then remove the funnel from the bulkhead.
    Tip: Use of the following tool(s) is recommended:
    • Plastic trim tool
  3. Pull the HVAC drain funnel and drain hose into the cabin, and then install hose clamp pliers on the drain hose to hold in position.
    Tip: Use of the following tool(s) is recommended:
    • Hose clamp pliers
  4. Release the datum that attaches the HVAC drain funnel to the drain hose, and then remove the funnel from the vehicle.
    Tip: Use of the following tool(s) is recommended:
    • Plastic trim tool

Install

  1. Position the HVAC drain funnel on the vehicle, and then install the datum that attaches the funnel to the drain hose.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the datum is fully engaged with the cutout in the drain hose.
  2. Remove the hose clamp pliers from the drain hose.
  3. Install the tabs (x2) that attach the HVAC drain funnel to the bulkhead.
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the funnel datum with the cutout in the bulkhead. Ensure both tabs are locked into the bulkhead.
  4. Install the HVAC assembly. See HVAC Assembly (Remove and Replace).