04/10/2022 10:11:30

Floor Panel - Mid - 2nd Row (6 Seat) (Remove and Replace)

Correction code 15303022 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open all four doors.
  2. Lower the LH and RH front windows.
  3. Move the LH and RH front seats forward.
  4. Remove the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  5. Remove the 2nd row floor mat. See Floor Mat - 2nd Row (Remove and Replace).
  6. With assistance, release the clips (x5) that attach the 2nd row mid floor panel to the vehicle, and then remove the floor panel from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Tilt the floor panel front edge upwards, and then remove the panel in a vertical position.
    Tip: Use of the following tool(s) is recommended:
    • Clip pry tool
    • Plastic trim tool

Install

  1. With assistance, position the 2nd row mid floor panel on the vehicle, and then install the clips (x5) that attach the floor panel to the vehicle.
  2. Install the 2nd row floor mat. See Floor Mat - 2nd Row (Remove and Replace).
  3. Install the LH and RH rear sill panel trims. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  4. Close the LH and RH falcon wings doors.
  5. Move the LH and RH front seats to original position.
  6. Raise the LH and RH front windows.
  7. Close the LH and RH front doors.