17/06/2022 13:23:14

Ground Cable - HV Battery (Remove and Replace)

Correction code 16100022 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
This procedure is a DRAFT, although it has been validated. Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near high voltage systems and components. Provide corrections and feedback to ServiceDevelopment@teslamotors.com.

Remove

  1. Move the vehicle to a 2 post lift. See Raise Vehicle - 2 Post Lift.
  2. Remove the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  3. Remove the front skid plate. See Skidplate - Front (Remove and Replace).
  4. Remove the bolt that attaches the HV battery ground cable to the LH front casting.
  5. Release the clip that attaches the HV battery ground cable to the HV battery.
  6. Remove the bolt that attaches the HV battery ground cable to the HV battery, route the ground cable out from behind the LH front casting boss, and then remove the ground cable from the vehicle.

Install

  1. Route the HV battery ground cable behind the LH front casting boss, and then install the bolt that attaches the ground cable to the HV battery.
    10 Nm (7.4 lbs-ft)
  2. Fasten the clip that attaches the HV battery ground cable to the HV battery.
  3. Install the bolt that attaches the HV battery ground cable to the LH front casting.
    10 Nm (7.4 lbs-ft)
  4. Install the front skid plate. See Skidplate - Front (Remove and Replace).
  5. Install the front aero shield panel. See Panel - Aero Shield - Front (Remove and Replace).
  6. Remove the vehicle from the 2 post lift. See Raise Vehicle - 2 Post Lift.