30/05/2024 14:10:07

Trim - Side - Trunk - LH (5 Seat) (Remove and Replace)

Correction code 15245002 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).
  2. Remove the LH trunk side mini nub.
  3. Remove the LH and RH rear trunk side garnishes. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  4. Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  5. Remove the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  6. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  7. Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  8. Remove the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  9. Remove the rear trunk crush can trim. See Trim - Crush Can - Rear Trunk - LH (Remove and Replace).
  10. Remove LH soft trim pocket bracket.
  11. Release the charge port manual cable release from the LH mid C-pillar zone bracket.
  12. Remove the LH mid C-pillar zone bracket. See Bracket - Zone - C-Pillar - Mid - LH (5 Seat) (Remove and Replace).
  13. Remove the clips (x4) that secure the trunk side trim, release the trunk tie down ring, disconnect the connector, and then remove the trunk side trim from vehicle.

Install

  1. Position the trunk side trim properly, connect the connector, insert the trunk tie down ring and install the clips (x4) that secure the trunk side trim.
  2. Install the LH mid C-pillar zone bracket. See Bracket - Zone - C-Pillar - Mid - LH (5 Seat) (Remove and Replace).
  3. Secure the charge port manual release cable onto the LH mid C-pillar zone bracket.
  4. Install the LH soft trim pocket bracket.
  5. Install the rear trunk crush can trim. See Trim - Crush Can - Rear Trunk - LH (Remove and Replace).
  6. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace).
  7. Install the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
  8. Install the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  9. Install the LH mid C-pillar trim. See Trim - C-Pillar - Mid - LH (Remove and Replace).
  10. Install the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace).
  11. Install the LH and RH rear trunk side garnishes. See Garnish - Rear Trunk - Side - LH (Remove and Replace).
  12. Install the LH trunk side mini nub.
  13. Install the trunk gap hider. See Gap Hider - Trunk (5 Seat) (Remove and Replace).