2022-10-05

Seal - Rear Door Cantrail - LH (Remove and Replace)

Correction code 11705402 0.90 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Remove the LH upper rear door glass assembly. See Door Glass Assembly - Rear - Upper - LH (Remove and Replace).
  2. Remove the push clips (x7) that attach the LH rear door front pinch sensor to the door assembly, release the sensor from the door assembly, and then use masking tape to tape the pinch sensor aside.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not pull the pinch sensor too far away from the door assembly as the connector is still connected.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure not to stress the harness.
  3. Remove the push clips (x7) that attach the LH rear door rear pinch sensor to the door assembly, release the sensor from the door assembly, and then us masking tape to tape the pinch sensor aside.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not pull the pinch sensor too far away from the door assembly as the connector is still connected.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure not to stress the harness.
  4. Loosen the nuts (x7) that attach the underside of the LH rear door cantrail seal to the door assembly.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not remove the fasteners.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
  5. Remove the bolts (x4) that attach the sides of the LH rear door cantrail seal to the door assembly, and then remove the seal from the vehicle.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T25 socket

Install

  1. Position the LH rear door cantrail seal onto the door assembly, and then install the bolts (x4) that attach the sides of the seal to the door assembly.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • T25 socket
  2. Tighten the nuts (x7) that attach the underside of the LH rear door cantrail seal to the door assembly.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
  3. Remove the masking tape from the LH rear door rear pinch sensor, position the sensor onto the door assembly, and then install the push clips (x7) that attach the sensor to the door assembly.
  4. Remove the masking tape from the LH rear door front pinch sensor, position the sensor onto the door assembly, and then install the push clips (x7) that attach the sensor to the door assembly.
  5. Install the LH upper rear door glass assembly. See Door Glass Assembly - Rear - Upper - LH (Remove and Replace).