28/07/2022 08:22:17

Side Repeater - Front - LH (HW3) (Remove and Replace)

Correction code 17403002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  3. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  4. Remove the LH front wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace).
  5. Apply masking tape to the LH fender at edges of LH front side repeater.
  6. Disconnect the LH front side repeater and camera electrical connectors (x2).
    Informational PurposesAn informational icon, calling your attention
    Note
    For the left/gray connector, gently slide the connector out slightly until the locking tab catches, and then press the tab down where indicated to release. For right/ brown connector, press the locking tab down where indicated by arrow to release.
  7. Press the tabs (x2) that attach the LH front side repeater to the vehicle while prying the repeater away from the LH fender to release it, and then remove the repeater from the vehicle.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If reinstalling the same side repeater, take care not to damage the mounting tabs.

Install

  1. Position the LH front side repeater onto the LH fender, and then carefully push the rear of the repeater through the mounting hole in the fender to engage the tabs (x2).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If reinstalling the same side repeater, make sure the mounting tabs are not damaged. If any of the tabs are damaged, replace the repeater.
  2. Connect the LH front side repeater and camera electrical connectors (x2).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Support the repeater from exterior to prevent damage to the retaining clips.
  3. Remove the masking tape from the LH fender.
  4. Install the LH front wheel arch liner. See Wheel Arch Liner - Front - LH (Remove and Replace).
  5. Raise the LH front window and close the LH front door.