14/06/2024 03:16:20

Brake Rotor - Front - LH (Remove and Replace)

Correction code 33010102 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2023-11-22: Added extra information for single rotor replacement.
Informational PurposesAn informational icon, calling your attention
Note
If only a single rotor needs replacing (due to damage), the corresponding axle rotor must be measured for runout and thickness. See Brake Rotor - Front - LH (Measure Runout).

Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  3. Remove the bolt that attaches the brake hose to the LH front knuckle.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Remove the bolts (x2) that attach the front brake caliper to the knuckle, and then allow the caliper to hang from the body using S-hooks.
    135 Nm (99.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 21 mm socket
  5. If installled, remove and discard the bolt that attaches the LH front rotor to the front knuckle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Some vehicles may not have this bolt installed from the factory.
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  6. Remove the LH front rotor from the hub.

Install

  1. Install the LH front rotor to the hub.
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to install the bolt that attaches the rotor to the hub.
  2. Clean the surfaces of the LH front brake rotor with brake cleaner, and then wipe the surface with a lint-free towel.
  3. Install the bolts (x2) that attach the front brake caliper to the knuckle.
    135 Nm (99.6 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 21 mm socket
  4. Install the bolt that attaches the brake hose bracket to the LH front knuckle.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Install the LH front wheel. See Wheel Assembly (Remove and Install).
  6. Burnish the brake pads. See Brake Pads - Burnishing
    Informational PurposesAn informational icon, calling your attention
    Note
    During vehicle driving, make sure that proper brake pedal feel and performance is achieved.
    Informational PurposesAn informational icon, calling your attention
    Note
    Add correction code 33013000 to the Service Visit.