Release Notes April-June 2023

Archived Release Notes:

Week Ending July 1, 2023

The following new procedure(s) were added:
  1. ECU - Trailer Hitch (Remove and Replace)
  2. Fascia Assembly - Front (HW4) (Remove and Replace)
  3. Fascia Assembly - Rear (HW4) (Remove and Replace)
  4. Fascia Assembly - Rear - Lower (Remove and Replace)
  5. Bracket - License Plate - Front (Rework)
The following procedure(s) were updated:
  1. A/C Refrigerant (Recovery and Recharge) -
  2. Brake Bleeder Machine (Flush) - Clarified steps and noted that this procedure is for the Bremsen brake bleeder machine.
  3. Closeout - Cup Holder - Seat - 3rd Row (Remove and Replace) - Revised steps.
  4. Harness - Fascia - Front (Remove and Replace) - Added HW4.
  5. Mechanism - Pivot - Touchscreen (Remove and Replace) - Added option links to remove HW3 touchscreen and HW4 touchscreen.
  6. Module - 2nd Row Seat Controller - LH (6 Seat) (Remove and Replace) - Updated routines to be run after seat controller module installation.
  7. Steering Yoke/Wheel (Remove and Replace) - Updated firmware reinstall step; it is to be performed whenever the steering wheel/yoke is replaced.
  8. Base Bracket - License Plate - Front (Remove and Replace) - Added additional steps to the removal and installation procedures for CN vehicles.

Week Ending June 24, 2023

The following procedure(s) were updated:
  1. A/C Compressor (Remove and Replace) -
  2. A/C Line - Supermanifold to HVAC (Remove and Replace) - Added link to vehicle electrical isolation procedure.
  3. A/C Refrigerant (Unknown Oil Quantity) (Recovery, Flush, and Recharge) - Added link to vehicle electrical isolation procedure.
  4. Applique - B-Pillar - LH (Remove and Replace) - Switch the steps so that DAS Reset occurs directly before the Camera Connection Test.
  5. Bracket - Compressor (Remove and Replace) -
  6. Camera - Forward Facing (Pitch Verification) - Updated images and added notes to check measurements before each setup.
  7. Camera - Rear Facing (HW4) (Remove and Replace) - Switch the steps so that DAS Reset occurs directly before the Camera Connection Test.
  8. Controller - Driver Seat (Remove and Replace) - Updated procedure not to remove seat from vehicle, added seat assignment routine and modified seat calibration routine.
  9. Gearbox Fluid - Rear Drive Unit (Plaid) (Drain and Refill) - Added PN for fill port adapter.
  10. Module - 2nd Row Seat Controller - LH (5 Seat) (Remove and Replace) - Seat controller module assignment routine added, firmware reinstall step modified.
  11. Subframe Assembly - Rear (Remove and Install) - Updated suspension ride height check.
  12. Vehicle HV Disablement Procedure - Updated photos to show CAT III probes being used and corrected photo for HV harness connection.
  13. Updated steps for seat belt linkage release/install in procedures that require seat removal and related trim removal.

Week Ending June 17, 2023

The following procedure(s) were updated:
  1. Door Glass - Front - LH (Adjust) - Added torque specification for inboard/outboard adjustment nuts.
  2. Inverter - Front Drive Unit (Remove and Replace) - Replaced Toolbox 3 routines with Touchscreen UI steps.
  3. Seat Assembly - 1st Row - LH (Remove and Replace) - Added change config steps for replacing non-FSAB seat with FSAB-equipped seat.

Week Ending June 10, 2023

The following procedure(s) were updated:
  1. Camera - Forward Facing (Pitch Verification)- Added specifications for HW4 and general image and step updates.
  2. Contactor - Fast Charge - HV Battery (Remove and Replace) - Added steps and notes to accommodate mica insulators and tape.
  3. Contactor - Positive - HV Battery (Remove and Replace) - Added steps and notes to accommodate mica insulators and tape.
  4. Cover - Rear Access - HV Battery (Remove and Replace) - Added steps to remove and install the mica insulator panel.
  5. Module - Air Suspension - ECU (Tesla) (LHD) (Remove and Replace) - Added information for HW4 vehicles.
  6. Module - Battery Controller (Remove and Replace) - Updated software reinstall steps.

Week Ending June 03, 2023

The following procedure(s) were updated:
  1. Tire - Front - LH (Remove and Replace) - Added caution about lubricant drying time.

Week Ending May 27, 2023

The following procedure(s) were updated:
  1. Door Glass - Front - LH (Adjust) - Added cleaning instructions to prevent glass damage.
  2. Door Glass - Front - LH (Remove and Replace) - Added cleaning instructions to prevent glass damage.
  3. Door Glass - Rear - LH (Adjust) - Added cleaning instructions to prevent glass damage.
  4. Door Glass - Rear - LH (Remove and Replace) - Added cleaning instructions to prevent glass damage.
  5. Headliner (Remove and Replace) - Added headliner shipping bag installation tip.
  6. HV Battery (AWD) (Remove and Install) - Reorganized Removal first steps.
  7. HV Battery (AWD) (Remove and Replace) - Added conspicuous discharge warning table.
  8. HV Battery (AWD) (Remove and Replace) - Reorganized Removal first steps.
  9. Platter Enclosure Coolant (Drain) - Added note that coolant cart pressure regulator is fixed at 20 psi.

Week Ending May 20, 2023

The following new procedure(s) were added:
  1. Compressor, Supermanifold, and A/C Lines (Remove and Replace)
  2. Horn - High Tone (Remove and Replace)
  3. Horn - Low Tone (Remove and Replace)

Week Ending May 13, 2023

The following new procedure(s) were added:
  1. Panel - Footrest - Front Passenger (LHD) (Remove and Install)
  2. SIM Card - Car Computer (Info-Ryzen) (Retrofit)
The following procedure(s) were updated:
  1. Back Rest - Driver (Remove and Replace) - Reorganized the procedure.
  2. Trim - Sill Panel - Rear - LH (Remove and Replace) -

Week Ending May 6, 2023

The following new procedure(s) were added:
  1. Headlights - Adjust (Global) (Tool Method)
  2. Headlights - Adjust (Global) (Wall Method)
  3. Sensor - Ultrasonic - Rear Door - LH (Remove and Replace)
The following procedure(s) were updated:
  1. Drive Unit - Rear (Plaid) (Remove and Replace) - Updated to latest validation.
  2. Electrical Precautions - Updated HV battery storage temperature guidance.
  3. Skidplate - Front (Remove and Replace) - Updated photos and added steps for additional bolts.
  4. Subframe Assembly - Rear (Plaid) (Remove and Install) - Added steps to conditionally remove rotor and release wheel arch liner.
  5. Vehicle HV Disablement Procedure - Updated current measurement step sequence and consistency.

Week Ending April 29, 2023

The following new procedure(s) were added:
  1. Sensor - Pressure Tube (Remove and Replace)
  2. Maintenance Service and Intervals
The following procedure(s) were updated:
  1. Actuator - E Release - Door - Front - LH (Remove and Replace) - Fixed the broken link.
  2. Airbag - Front Passenger (Remove and Replace) - Reorganized the procedure..
  3. Cover - Inverter - Drive Unit - Front (Remove and Replace) - Updated "screw clip" to "brush clip".
  4. Module - Body Controller - RH (Remove and Replace) - Added steps to loosen the RH front primary seal to aid with trim removal.
  5. Wheel - Front - LH (Remove and Replace) - Reorganized the procedure..

Week Ending April 22, 2023

The following new procedure(s) were added:
  1. 5003 - Charging Adapters - Created new section and moved Firmware Update - CHAdeMO Charging Adapter to there.
The following procedure(s) were updated:
  1. Aero Lens - Instrument Panel (Remove and Replace) - Added note for additional ground strap PN for non-HW4 vehicles.
  2. Door Glass - Front - LH (Adjust) - Cleaned up.
  3. Puddle Light - Front Door - LH (Remove and Replace) - Fixed the broken link.
  4. Side Repeater Camera - Front - LH (HW4) (Remove and Replace) - Added HW4 camera connection test steps.

Week Ending April 15, 2023

The following procedure(s) were updated:
  1. Alignment Requirement - Suspension - Updated alignment requirement tables.
  2. Cover - Front Access - HV Battery (Remove and Install) - Added conditional steps for when there is a doubler around the front access cover.
  3. Fender Garnish and Wheel Fairing Assembly - Front - LH (Remove and Replace) - Added steps for HW4 vehicles.
  4. Harness - Liftgate (Remove and Replace) - Added steps for HW4 vehicles.
  5. Heater - Radar (Remove and Replace) -
  6. Inverter - LH - Rear Drive Unit (Plaid) (Remove and Replace) - Reordered steps around the before replacement dashboard.
  7. Liftgate Drain - LH (Remove and Replace) - Fixed the broken link.
  8. Module - Battery Controller (Remove and Replace) - Cleaned up.
  9. Module - Body Controller - LH (Remove and Replace) - Cleaned up.
  10. Module - Body Controller - RH (Remove and Replace) - Added steps to loosen the RH front primary seal to aid with trim removal.
  11. Radar - Interior (Remove and Replace) - Cleaned up.
  12. Sensor - Radar - Front (Remove and Replace) -
  13. Speaker - Dash - LH (Remove and Replace) - Cleaned up.
  14. Supermanifold (Remove and Replace) - Revised procedure.

Week Ending April 8, 2023

The following new procedure(s) were added:
  1. HV Battery Revision -F to Revision -H (5-Seat) (Retrofit)
  2. HV Battery Revision -F to Revision -H (6-Seat) (Retrofit)
  3. Module - Rear Door Controller- LH (Remove and Replace)
  4. Touchscreen (HW4) (Remove and Replace)
The following procedure(s) were updated:
  1. Aero Lens - Instrument Panel (Remove and Replace) - Added note on reworked datums/mounting tabs.
  2. Halfshaft - Front Drive Unit - LH (Remove and Replace) - Added test drive at the end of procedure as per latest GSD validation.
  3. Touchscreen (HW3) (Remove and Replace) - Added steps for the electrical connectors for the tilt motors (if equipped).
  4. Underhood Storage Unit (Remove and Install) - Added check for proper routing of and possible damage to HVIL harness branch.
  5. Underhood Storage Unit (Remove and Replace) - Added check for proper routing of and possible damage to HVIL harness branch.