05/12/2024 14:28:58

Latch - Seat Back - 2nd Row Seat - LH (Remove and Replace)

Correction code 13055902 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure proper PPE is worn when performing the below procedure.

  • 2024-12-05: Updated the seat back latch-to-seat assembly bolts torque spec to 40 Nm.
  • 2024-02-21: Added note not to perform RH latch replacement.
Informational PurposesAn informational icon, calling your attention
Note
Do not perform this procedure on the RH side of the vehicle. The RH seat back latch is not a serviceable part.

Remove

  1. Open LH doors and lower the LH windows.
  2. Move driver seat forward.
  3. Remove the LH 2nd row seat back panel. See
  4. Remove the LH 2nd row seat back side cover. See .
  5. Remove the LH 2nd row headrest. See
  6. Remove the LH 2nd row backrest headrest guides.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the headrest guide locking tabs and slide headrest guide out of frame assembly. Guide with adjustment button installed inboard.
  7. Disconnect the LH 2nd row backrest harness, and then release the clip that attaches the harness to the backrest.
  8. Fold LH 2nd row seat to the vertical position, but do not latch the seat back.
  9. Release the clips (x4) that attach the LH 2nd row backrest cushion to the seat assembly.
  10. Remove the clips (x3) that attach the LH 2nd row seat shoulder plastic trim to the seat assembly.
  11. Release the clips (x5) that attach the LH 2nd row shoulder plastic trim to the frame assembly, and then partially release the shoulder plastic trim and set the trim aside.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the fold switch harness and connector are not excessively pulled. Use a plastic trim tool or shop towel to hold the trim away from the seat frame.
  12. Pull the red tab to release the connector lock, and then disconnect the LH 2nd row seat seat back latch electrical connector.
  13. Remove the bolts (x2) that attach the LH 2nd row seat seat back latch to the seat assembly, and then remove the latch from the vehicle.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket

Install

  1. Position the LH 2nd row seat seat back latch onto the seat assembly, and then install the bolts (x2) that attach the latch to the seat.
    40 Nm (29.5 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 13 mm socket
  2. Connect the LH 2nd row seat seat back latch electrical connector, and then engage the connector lock.
  3. Position the LH 2nd row shoulder plastic trim to the seat assembly, and then fasten the clips (x5) that attach the trim to the seat assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove the plastic trim tool or shop towel. Ensure the fold switch harness and connector are properly placed.
  4. Install the clips (x3) that attach the LH 2nd row seat shoulder plastic trim to the seat assembly.
  5. Install the clips (x4) that attach the LH 2nd row backrest cushion to the seat assembly.
  6. Fold LH 2nd row seat to the down position.
  7. Install the LH 2nd row backrest LH and RH headrest guides.
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the guides into the backrest frame. Ensure the headrest guide locking tabs are fully engaged. Guide with adjustment button installed inboard.
  8. Install the LH 2nd row headrest. See .
  9. Install the LH 2nd row seat back side cover. See .
  10. Install the LH 2nd row seat back panel. See
  11. Move driver seat to original position.
  12. Raise the LH windows and close the LH doors.