22/05/2018 13:26:36

Striker - Seat Back - 2nd Row - RH (Remove and Replace)

Correction code 13056402 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the LH and RH 2nd row seat side bolsters. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).
  3. Remove the LH side rail trim. See Trim - Side Rail - LH (Remove and Replace).
  4. Remove the LH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  5. Remove the RH side rail trim. See Trim - Side Rail - LH (Remove and Replace).
  6. Remove the RH upper C-pillar trim. See Trim - C-Pillar - Upper - LH (Remove and Replace).
  7. Release the clips (x4) that attach the front of the package tray to the body.
  8. Pull the package tray forward, and then lift up the package tray to access the seat back striker.
    Informational PurposesAn informational icon, calling your attention
    Note
    Support the package tray in the raised position.
  9. Remove the bolts that attach the 2nd row RH seat back striker to the body, and then remove the striker from the vehicle.
    16 Nm (11.8 lbs-ft)

Install

Installation procedure is the reverse of removal.