Bracket - Headlight - LH (Remove and Replace)
    
    Correction code
    
      
                           17400112
                           0.78
                           
                           
        
          NOTE: Unless otherwise explicitly
          stated in the procedure, the above correction code and FRT reflect all of the work
          required to perform this procedure, including the linked procedures. Do not stack correction codes unless
            explicitly told to do so.
        
          NOTE: See Flat Rate
            Times to learn more about FRTs and how they are created. To provide feedback on
          FRT values, email ServiceManualFeedback@tesla.com. 
        
          NOTE: See Personal Protection to make sure wearing proper PPE when
          performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
      
                        
    
  
- 1080559-20-A TOOL, TORQUE SCREWDRIVER, 0.8-2.0NM (NA, APAC)
 - 1080559-21-A TOOL, TORQUE SCREWDRIVER, 0.8-2.0NM (EMEA)
 
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes | 
|---|---|---|---|---|
| Screws that attach the headlight bracket to the headlight | 
              ![]() 1.8 Nm (1.3 lbs-ft)   | 
            
              
  | 
            Reuse | 
Remove
- Remove the headlight. See Headlight - LH (Remove and Replace).
 - 
          Remove the screws that attach the bracket to the headlight, and then remove the bracket from the headlight.
          NoteUse of the following tool(s) is recommended:
- Torx T25 socket
 - 6 in extension
 
 
Install
- 
          Install the screws that attach the bracket to the headlight. 
1.8 Nm (1.3 lbs-ft)NoteUse of the following tool(s) is recommended:- Torx T25 socket
 - 6 in extension
 
 - 
          Install the headlight. See Headlight - LH (Remove and Replace).
          CAUTIONMake sure to adjust the headlights after installing the headlight.