Module - HomeLink Transmitter (Remove and Replace)
Correction code
17154202
0.48
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
- 2025-07-14: Updated post-replacement routine instructions.
Remove
-
Disconnect 12V power. See
12V/LV Power (Disconnect and Connect).
CAUTIONPerform the 12V disconnect procedure exactly as detailed to avoid unexpected functionality of the homelink transmitter and touchscreen icon.
- Remove the front fascia. See Fascia - Front (Remove and Install).
- Disconnect the electrical connector from the HomeLink transmitter module.
- Release the tab, and then slide the HomeLink transmitter module to the right to remove it from the vehicle.
Install
- Install the HomeLink transmitter module on the bracket.
- Connect the electrical connector to the HomeLink transmitter module.
- Install the front fascia. See Fascia - Front (Remove and Install).
- Reconnect 12V power. See 12V/LV Power (Disconnect and Connect).
- Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): TEST-SELF_VCFRONT_X_HOMELINKvia Toolbox: (link)via Service Mode: Low Voltage ➜ HomeLink ➜ Test HomeLink