USB Hub - Center Console - Rear (Remove and Replace)
Correction code
21260602
0.18
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the center console air vent panel. See Assembly - Rear Vent - Center Console (Remove and Replace).
-
Remove the screws that attach the vent unit to the center console air vent panel, and remove the vent unit from the panel.
1.6 Nm (1.2 lbs-ft)
-
Remove the screws that attach the rear center console USB hub to the center console air vent, and remove the USB hub from the vent.
1.1 Nm (.8 lbs-ft)
Install
Installation procedure is the reverse of removal.