08/10/2019 16:04:11

C-Clips - Strut - Trunk - LH (Remove and Replace)

Correction code 11330712 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the trunk and support it with a prop.
  2. Release the clip that attaches the lower end of the LH trunk gas strut to the hinge on the vehicle.
  3. Release the clip that attaches the upper end of the LH trunk gas strut to the hinge on the trunk lid, and then remove the strut from the vehicle.
  4. Remove the clips (x2) from the LH trunk gas strut.

Install

  1. Use snap ring pliers to install new clips (x2) on the gas strut.
    Informational PurposesAn informational icon, calling your attention
    Note
    Align the ends of the clip with the grooves on the strut, and then push the clip onto the strut until the clip is fully seated in the notch.
    Figure 1. Trunk lid side of strut shown, body side similar
  2. Clean the strut ball studs on the hood mount and hood hinge (x2) with a clean rag.
  3. Position the LH trunk gas strut on the body side hinge ball stud, and then install the clip that attaches the strut to the hinge.
  4. Position the LH trunk gas strut on the trunk lid side hinge ball stud, and then install the clip that attaches the strut to the hinge.
  5. Remove the prop from the trunk.
  6. Close and open the trunk 3 times to verify proper gas strut installation.