2020-11-12

Bracket - Retainer - Busbar - Charge Port to HV Battery (3-Phase) (Remove and Replace)

Correction code 44018202 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 3-phase charge port to HV battery busbar safety cap. See Safety Cap - Busbar - Charge Port to HV Battery (Remove and Replace).
  2. Use a pick to gently release the tabs (x3) that attach the busbar retainer bracket to the busbar bracket, and then remove the retainer bracket from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not pry with excessive force, as doing so could damage the brackets.

Install

Installation procedure is the reverse of removal.