20/02/2024 21:33:37

Window Motor / Regulator Assembly - Rear - LH (Remove and Replace)

Correction code 11502202 0.54 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1054712-00-A Rivnut Install Kit, for NA
  • 1054712-01-A Rivnut Install Kit, for EMEA
  • 1004296-00-A Service rivnut
  • 1015888-00-C Service bolt
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The side impact airbag deployment depends on the rear door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the rear door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the rear doors and their components.

Remove

  1. Remove the LH rear door glass. See Glass - Door - LH - Rear (Remove and Replace).
  2. Disconnect the electrical harness from LH rear window motor/regulator assembly.
  3. Release the clips (x2) that attach the manual latch release cable to the LH rear window motor/regulator assembly.
  4. Remove the screws (x13) and release the metal clip that attach the LH rear window motor/regulator assembly to the LH rear door, and then remove the assembly from the door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Never loosen or remove the nuts (x4) that attach the regulator arms to the assembly closeout panel.

Install

  1. Inspect the condition of the mounting holes for the LH rear window motor/regulator assembly.
    Informational PurposesAn informational icon, calling your attention
    Note
    Install rivnuts where any of the mounting hole threads are stripped. Use a 7.5mm drill to prepare the hole for rivnut installation.
  2. Install the LH rear window motor/regulator assembly to the LH rear door, hand-install the screws (x13) and fasten the metal clip that attach the assembly to the door, and then tighten the screws.
    4 Nm (2.9 lbs-ft)
  3. Fasten the clips (x2) that attach the manual latch release cable to the LH rear window motor/regulator assembly.
  4. Connect the electrical harness to LH rear window motor/regulator assembly.
  5. Install the LH rear door glass. See Glass - Door - LH - Rear (Remove and Replace).
  6. Recalibrate the LH rear window regulator. See Window Regulator (Recalibrate).