21/03/2024 12:30:47
TPMS (Sensor ID Drive Learn)
Correction code 34041150 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2024-03-11: Removed Toolbox routine from the procedure and added additional instruction for Continental systems.
Procedure
- For Continental systems only: Auto-learn will only start after the drive rail was off for more than 20 minutes. In case you cycled the drive rail, for example to open the gate, auto-learn will not start because the drive rail was not off for more than 20 minutes. In this case, resetting VCFRONT, and with that the TPMS ECU, triggers auto-learn again. To reset VCFRONT/TPMS ECU, on the touchscreen, touch .
- Test drive the vehicle to at least 15 mph (24 kph) for 1-3 minutes to reconnect the TPMS sensors.
- Confirm on the vehicle touchscreen that all 4 TPMS sensors are providing tire pressure readings.