2019-03-11

Bracket - License Plate - Rear (EMEA) (Remove and Replace)

Correction code 12072302 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the screws (x4) that attach the rear license plate to the rear license plate bracket, if a license plate is installed. Otherwise, skip to the next step.
  2. Remove the screws (x2) that attach the rear license plate bracket to the vehicle, and then remove the bracket from the vehicle.

Install

  1. Verify that the thread inserts were not damaged during the removal of the screws.
  2. Clean the trunk lid surface with isopropyl alcohol (IPA) wipes, and then allow the surface to dry before continuing.
  3. Install the screws (x2) that attach the rear license plate bracket to the vehicle.
    1.2 Nm (.9 lbs-ft)
  4. Install the screws (x4) that attach the rear license plate on the rear license plate bracket, if applicable.
    1.2 Nm (.9 lbs-ft)