2021-01-28

Bracket - Fascia Center To Fender - LH (Remove and Replace)

Correction code 10018102 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Bracket - Fascia Center To Fender - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH front fascia center bracket to the vehicle
3 Nm (2.2 lbs-ft)
  • Torx T20 socket
  • 4 in extension
  • Ratchet/torque wrench
  • Wurth ¼ in hexagon 1 Nm - 5 Nm torque wrench (installation only)
Reuse

Remove

  1. Remove the front fascia. See Fascia - Front (Remove and Install).
  2. Remove the bolt that attaches the LH fascia center to fender bracket to the fender, and then remove the bracket from the vehicle.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 4 in extension
    • Ratchet/torque wrench
    • Wurth ¼ in hexagon 1 Nm - 5 Nm torque wrench (installation only)

Install

Installation procedure is the reverse of removal.