08/09/2022 15:38:14

Hub - Front - LH (RWD) (Remove and Replace)

Correction code 31010602 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1062500-00-A Card, Magnetic Field Viewer
  • 10821717-00-A S-Hook

Torque Specifications

Table 1. Torque Specifications: Hub - Front - LH (RWD) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the LH front hub to the knuckle
85 Nm (62.7 lbs-ft)
  • 18 mm socket
  • 3 in extension
 Reuse

Install

  1. Check the tone ring on the LH front hub prior to installation: Use a magnetic field viewing card to make sure that the magnetic field on the tone ring is not damaged.
  2. Position the LH front hub on the knuckle, and then install the bolts that attach the hub to the knuckle.
    85 Nm (62.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 18 mm socket
    • 3 in extension
  3. Install the LH front brake rotor. See Brake Rotor - Front - LH (Remove and Replace).
  4. Install LH front wheel. See Wheel Assembly (Remove and Install).
  5. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust as a separate activity. See Alignment Requirement - Suspension.