16/07/2020 08:56:12

Ankle Catcher (Remove and Replace)

Correction code 10011202 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the front fascia. See Fascia - Front (Remove and Install).
  2. Remove the bolts that attach the bottom of the cooling fan module to the ankle catcher.
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the condenser fan module up to ease removal of the bolts.
  3. Loosen but do not remove the bolts that attach the upper section of the front end carrier to the body.
  4. Remove the bolts that attach the front end carrier to the crash cans.
  5. Move the front end carrier forward, slide the ankle catcher off the front end carrier locating posts, and then remove the ankle catcher from the vehicle.

Install

  1. Position the ankle carrier onto the front end carrier locating posts, and then slide the ankle catcher into place.
  2. Hand-tighten the bolts that attach the front end carrier to the crash cans.
  3. Torque the bolts that attach the front end carrier to the crash cans.
    16 Nm (11.8 lbs-ft)
  4. Tighten the bolts that attach the upper section of the front end carrier to the body.
    16 Nm (11.8 lbs-ft)
  5. Install the bolts that attach the bottom of the cooling fan module to the ankle catcher.
    10 Nm (7.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Lift the condenser fan module up to ease installation of the bolts.
  6. Install the front fascia. See Fascia - Front (Remove and Install).