16/12/2021 14:38:39

Airbag - Front Passenger (Remove and Replace)

Correction code 20010302 1.98 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see Airbag and Supplementary Restraint System (SRS) Precautions.
Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Supplementary restraint system (SRS) components can be hazardous if not handled properly. See Airbag and Supplementary Restraint System (SRS) Precautions.

Remove

  1. Remove the IP carrier. See IP Carrier (Remove and Install).
  2. Apply pressure along the front edge of the airbag assembly, and while doing so, flex the IP passenger airbag surround to release each of the 6 airbag tabs from the IP carrier surround.
  3. Pivot the airbag up, unhook the 7 tabs at the rear of the airbag from the IP carrier surround, and then remove the airbag from the IP carrier.

Install

  1. Insert the 7 tabs of the rear of the airbag into the matching openings of the IP carrier surround.
  2. Pivot the airbag into the IP carrier until the 6 tabs at the front of the airbag lock into place.
  3. Install the IP carrier. See IP Carrier (Remove and Install).