19/10/2020 09:42:28

Cover - Airbag - Knee - Driver (Remove and Replace)

Correction code 14056002 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the driver knee airbag. See Airbag - Knee - Driver (Remove and Install).
  2. Use a flat head screwdriver to apply pressure along the rear edge of the airbag assembly, and while doing so, flex the knee airbag cover surround to release each of the 5 airbag tabs from the cover.

Install

  1. Install the driver knee airbag into the cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    Push the tabs into the cover from the side facing the bulkhead, and then push down the remaining tabs into the cover until fully seated.
  2. Pivot the airbag into the cover until the 5 tabs at the rear of the airbag lock into place
  3. Install the driver knee airbag assembly. See Airbag - Knee - Driver (Remove and Install).