10/12/2023 18:21:47

Seal - Outer Belt - Front Door - LH (Adjust)

Correction code 11700004 Adjustable FRT NOTE: This procedure uses an adjustable correction code. Use the correction code listed above and manually enter the actual amount of time spent performing this procedure. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-12-11: Updated the original nonadjustable correction code to the new adjustable one.

Remove

  1. Open the LH front door and lower the LH front window fully.
  2. Pull up and then pry to release the LH front door outer belt seal from the door using a plastic trim tool, and then remove the seal from the door.
  3. Insert the plastic trim tool into the seal channel and twist the tool inboard to open the channel to remove the plastic X-datum.
  4. With the help of the plastic trim tool, press the seal channel closed with your thumb.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure seal fits properly on the door hem flange.

Install

  1. Install the LH front door outer belt seal onto the door assembly by pushing down to secure it.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use P-80 emulsion lubricant to ease installation of the seal.
  2. Close the LH front door and raise the LH front window.